Neal 550 wiring help

Home Forums Sealcoating Equipment Forum Neal 550 wiring help

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #5572

    I have a Neal 550 that had an engine fire. I replaced the engine but I’m not sure I have the wires correct. Mainly the hot wire leading to the hydraulic dump valve. Should I run the hot wire through the switch that activates the material pump or just run a hot wire from the key switch so the hydraulic dump valve has power whenever the engine is running?

    Thanks in advance for any info you can give me.


    Call Gerrold or Eric at Neal Manufacturing. They will help you! 770-830-1282

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.